Boiler Burner Fault Code Table (How To Handle Boiler Burner Faults)

<h2>What does the red light on the boiler gas burner mean</h2>

<p>The meaning of the red light on the boiler gas burner is that it is only when the combustion engine malfunctions that the burner lights up</ P>

<p>The burner of a gas boiler is the core of all structural layouts, and the quality and maintenance of the burner directly affect the combustion efficiency of the gas boiler. But even the best burner will still experience some degree of malfunction</ P>

<p>The reason for the red light on the gas burner is also due to the presence of carbon residue and oil stains in the gap between the ignition rods; Broken, damp, and leaking ignition rods; The distance between the ignition rods is incorrect, too long or too short; The insulation outer skin of the ignition rod is damaged and there is a short circuit to ground; Failure of ignition cables and transformers; Cable breakage, damaged connectors causing short circuits during ignition, transformer disconnection, or other malfunctions. From</p>

<p>Extended Information:</p>

<p>The precautions for using gas boiler burners are as follows:</p>

<p>After long-term operation, boilers inevitably encounter problems such as scale and rust. The main reason for the formation of scale in the boiler is the presence of hardness components in the feed water. After continuous evaporation and concentration at high temperature and high pressure, a series of physical and chemical reactions occur in the furnace</ P>

<p>It will lead to a decrease in heat absorption in the water-cooled wall of the boiler, an increase in the outlet temperature of the boiler furnace, and an increase in boiler losses. At the same time, the scaling inside the water-cooled wall reduces the heat transfer effect, which may lead to an increase in the temperature of the water-cooled wall tube wall and cause the water-cooled wall to burst, affecting the safe operation of the boiler</ P>

<p>Reference source: Phoenix Net - Nearly 10000 gas boilers will complete low nitrogen transformation by the end of next year</p>

<p>Reference source: Sogou Encyclopedia - Gas boiler burners are similar to household stoves, but we do not know the characteristics of the stove when it works, only know that it is a stove. In fact, whether it is a stove or a boiler burner, they all have a common characteristic, which is to control the "air fuel ratio", so that combustible gases and air are mixed in the best proportion and burned to improve combustion efficiency. The combustion engine performs better in combustion control than household stoves. A combustion engine has multiple monitoring probes that, under the command of a computer, control the feed rate of gas, the amount of air entering, and so on according to manually set requirements. At the same time, the combustion engine also has safety functions such as anti backfire and explosion-proof combustion. The red light on the boiler burner indicates that the burner has malfunctioned and has not been ignited properly. It needs to be checked and reset by zd before restarting. If it is a gas burner, it is necessary to check whether the gas supply is normal. To confirm that the gas supply is normal, it is necessary to check whether there are problems with the adjustment of air and gas, ignition, flame detection, and other aspects; If it is a fuel burner, it is necessary to check whether the oil pump, nozzle, ignition, and flame detection are normal. For the problems found during the inspection, corresponding measures need to be taken to handle them, then reset and restart the burner. The possibility of excessive or low air pressure is high</p>

<h2>Fault codes for gas boilers</h2>

<p>We need to carefully examine the situation of ignition faults in gas boilers. one