Product model: | |
---|---|
Availability: | |
Quantity: | |
Honeywell TBC2800A1000 combustion controller
Not only can it be used in conjunction with traditional continuous combustion, but it can also be widely used in current temperature uniformity
To achieve optimized control of the combustion system in pulse combustion control with high requirements.
Installation Introduction:
The base can be installed directly on a DIN rail or on a fixed plate using two M4 screws,
Note that in order to meet the IP54 sealing level, a sealing gasket is required when installing with screws; There are 7 on the base
M16 can knock down reserved holes and match with plastic sealing joints, used for connecting incoming and outgoing cables.
Frequent opening and closing within T2 time. If the starting signal is on or off more than three times during the same starting process, the controller enters
Fault locking status, with LED flashing displaying fault code "4". 6. The time between two starts is too short
If the startup is too frequent, the LED will flash and display the fault code "7". 7. Continuous remote reset
The continuous remote reset signal input time received by the controller cannot exceed T7, otherwise the LED will flash and display the fault code "6",
The equipment remains in its original operating state. When the remote reset signal disappears and the fault is resolved, the Honeywell TBC2800A1000 combustion controller
8. If the remote reset frequency is too high, LED flashes to display fault code "5". Control
The device enters a fault locked state, and this fault can only be resolved through the controller's button.
Honeywell TBC2800A1000 combustion controller
Not only can it be used in conjunction with traditional continuous combustion, but it can also be widely used in current temperature uniformity
To achieve optimized control of the combustion system in pulse combustion control with high requirements.
Installation Introduction:
The base can be installed directly on a DIN rail or on a fixed plate using two M4 screws,
Note that in order to meet the IP54 sealing level, a sealing gasket is required when installing with screws; There are 7 on the base
M16 can knock down reserved holes and match with plastic sealing joints, used for connecting incoming and outgoing cables.
Frequent opening and closing within T2 time. If the starting signal is on or off more than three times during the same starting process, the controller enters
Fault locking status, with LED flashing displaying fault code "4". 6. The time between two starts is too short
If the startup is too frequent, the LED will flash and display the fault code "7". 7. Continuous remote reset
The continuous remote reset signal input time received by the controller cannot exceed T7, otherwise the LED will flash and display the fault code "6",
The equipment remains in its original operating state. When the remote reset signal disappears and the fault is resolved, the Honeywell TBC2800A1000 combustion controller
8. If the remote reset frequency is too high, LED flashes to display fault code "5". Control
The device enters a fault locked state, and this fault can only be resolved through the controller's button.